Effect of sieving on ex-situ soil respiration of soils from three land use types

This study aims to investigate the effect of sieving on ex situ soil respiration (CO2 flux) measurements from different land use types. We collected soils (0–10 cm) from arable, grassland and woodland sites, allocated them to either sieved (4-mm mesh, freshly sieved) or intact core treatments and incubated them in gas-tight jars for 40 days at 10 °C. Headspace gas was collected on days 1, 3, 17, 24, 31 and 38 and CO2 analysed. Our results showed that sieving (4 mm) did not significantly influence soil respiration measurements, probably because micro aggregates (< 0.25 mm) remain intact after sieving. However, soils collected from grassland soil released more CO2 compared with those collected from woodland and arable soils, irrespective of sieving treatments. The higher CO2 from grassland soil compared with woodland and arable soils was attributed to the differences in the water holding capacity and the quantity and stoichiometry of the organic matter between the three soils. We conclude that soils sieved prior to ex situ respiration experiments provide realistic respiration measurements. This finding lends support to soil scientists planning a sampling strategy that better represents the inhomogeneity of field conditions by pooling, homogenising and sieving samples, without fear of obtaining unrepresentative CO2 flux measurements caused by the disruption of soil architecture

Taming Charge Transport in Semiconducting Polymers with Branched Alkyl Side Chains

National Research Fund of Luxembourg. Grant Number: 6932623; Croucher Foundation; Kodak Graduate Fellowship; Office of Naval Research. Grant Number: N00014-17-1-2214; U.S. Department of Energy. Grant Number: DE-AC02-76SF0051

Wafer-scale two-dimensional semiconductors from printed oxide skin of liquid metals

© The Author(s) 2017. A variety of deposition methods for two-dimensional crystals have been demonstrated; however, their wafer-scale deposition remains a challenge. Here we introduce a technique for depositing and patterning of wafer-scale two-dimensional metal chalcogenide compounds by transforming the native interfacial metal oxide layer of low melting point metal precursors (group III and IV) in liquid form. In an oxygen-containing atmosphere, these metals establish an atomically thin oxide layer in a self-limiting reaction. The layer increases the wettability of the liquid metal placed on oxygen-terminated substrates, leaving the thin oxide layer behind. In the case of liquid gallium, the oxide skin attaches exclusively to a substrate and is then sulfurized via a relatively low temperature process. By controlling the surface chemistry of the substrate, we produce large area two-dimensional semiconducting GaS of unit cell thickness (∼1.5 nm). The presented deposition and patterning method offers great commercial potential for wafer-scale processes

Corrigendum: Wafer-scale two-dimensional semiconductors from printed oxide skin of liquid metals.

Nature Communications 8: Article number: 14482; published: 17 February 2017; Updated: 22 March 2017 The original version of this Article contained a typographical error in the spelling of the author Omid Kavehei, which was incorrectly given as Omid Kevehei. This has now been corrected in both the PDF and HTML versions of the Article.</jats:p

A stretchable and biodegradable strain and pressure sensor for orthopaedic application

The ability to monitor, in real time, the mechanical forces on tendons after surgical repair could allow personalized rehabilitation programmes to be developed for recovering patients. However, the development of devices capable of such measurements has been hindered by the strict requirements of biocompatible materials and the need for sensors with satisfactory performance. Here we report an implantable pressure and strain sensor made entirely of biodegradable materials. The sensor is designed to degrade after its useful lifetime, eliminating the need for a second surgery to remove the device. It can measure strain and pressure independently using two vertically isolated sensors capable of discriminating strain as small as 0.4% and the pressure exerted by a grain of salt (12 Pa), without them interfering with one another. The device has minimal hysteresis, a response time in the millisecond range, and an excellent cycling stability for strain and pressure sensing, respectively. We have incorporated a biodegradable elastomer optimized to improve the strain cycling performances by 54%. An in vivo study shows that the sensor exhibits excellent biocompatibility and function in a rat model, illustrating the potential applicability of the device to the real-time monitoring of tendon healing

Non-Conjugated Flexible Linkers in Semiconducting Polymers: A Pathway to Improved Processability without Compromising Device Performance

Semiconducting polymers, in contrast to inorganic silicon, are solution processable and can potentially be printed cost efficiently on flexible large‐area substrates. However to do so it is of paramount importance to formulate the polymeric semiconductors into inks with specific viscosities. Herein, the synthesis of a new highly soluble isoindigo monomer and its incorporation into low bandgap semiconducting polymers is presented. Non‐conjugated flexible linkers are introduced into the conjugated backbone in order to modulate the materials processability. The viscoelastic properties of the new polymers are studied in detail by means of rheometry and dynamical mechanical analysis. The solution viscosity is directly proportional to the content of non‐conjugated linkers in the polymer backbone. In organic field‐effect transistors maximum hole mobilities of 1.7 cm2 V−1 s−1 are achieved with the new polymers. Due to the enhanced solubility all‐polymer solar cells are fabricated by solution shearing, reaching power conversion efficiency values of 3.7%

Taming Charge Transport in Semiconducting Polymers with Branched Alkyl Side Chains

The solid-state packing and polymer orientation relative to the substrate are key properties to control in order to achieve high charge carrier mobilities in organic field effect transistors (OFET). Intuitively, shorter side chains are expected to yield higher charge carrier mobilities because of a denser solid state packing motif and a higher ratio of charge transport moieties. However our findings suggest that the polymer chain orientation plays a crucial role in high-performing diketopyrrolopyrrole-based polymers. By synthesizing a series of DPP-based polymers with different branched alkyl side chain lengths, it is shown that the polymer orientation depends on the branched alkyl chain lengths and that the highest carrier mobilities are obtained only if the polymer adopts a mixed face-on/edge-on orientation, which allows the formation of 3D carrier channels in an otherwise edge-on-oriented polymer chain network. Time-of-flight measurements performed on the various polymer films support this hypothesis by showing higher out-of-plane carrier mobilities for the partially face-on-oriented polymers. Additionally, a favorable morphology is mimicked by blending a face-on polymer into an exclusively edge-on oriented polymer, resulting in higher charge carrier mobilities and opening up a new avenue for the fabrication of high performing OFET devices

Highly stretchable polymer semiconductor films through the nanoconfinement effect

Soft and conformable wearable electronics require stretchable semiconductors, but existing ones typically sacrifice charge transport mobility to achieve stretchability. We explore a concept based on the nanoconfinement of polymers to substantially improve the stretchability of polymer semiconductors, without affecting charge transport mobility. The increased polymer chain dynamics under nanoconfinement significantly reduces the modulus of the conjugated polymer and largely delays the onset of crack formation under strain. As a result, our fabricated semiconducting film can be stretched up to 100% strain without affecting mobility, retaining values comparable to that of amorphous silicon. The fully stretchable transistors exhibit high biaxial stretchability with minimal change in on current even when poked with a sharp object. We demonstrate a skinlike finger-wearable driver for a light-emitting di

Graphene Photonics and Optoelectronics

The richness of optical and electronic properties of graphene attracts enormous interest. Graphene has high mobility and optical transparency, in addition to flexibility, robustness and environmental stability. So far, the main focus has been on fundamental physics and electronic devices. However, we believe its true potential to be in photonics and optoelectronics, where the combination of its unique optical and electronic properties can be fully exploited, even in the absence of a bandgap, and the linear dispersion of the Dirac electrons enables ultra-wide-band tunability. The rise of graphene in photonics and optoelectronics is shown by several recent results, ranging from solar cells and light emitting devices, to touch screens, photodetectors and ultrafast lasers. Here we review the state of the art in this emerging field.Comment: Review Nature Photonics, in pres

A previously functional tetracycline-regulated transactivator fails to target gene expression to the bone

<p>Abstract</p> <p>Background</p> <p>The tetracycline-controlled transactivator system is a powerful tool to control gene expression <it>in vitro </it>and to generate consistent and conditional transgenic <it>in vivo </it>model organisms. It has been widely used to study gene function and to explore pathological mechanisms involved in human diseases. The system permits the regulation of the expression of a target gene, both temporally and quantitatively, by the application of tetracycline or its derivative, doxycycline. In addition, it offers the possibility to restrict gene expression in a spatial fashion by utilizing tissue-specific promoters to drive the transactivator.</p> <p>Findings</p> <p>In this study, we report our problems using a reverse tetracycline-regulated transactivator (rtTA) in a transgenic mouse model system for the bone-specific expression of the Hutchinson-Gilford progeria syndrome mutation. Even though prior studies have been successful utilizing the same rtTA, expression analysis of the transactivator revealed insufficient activity for regulating the transgene expression in our system. The absence of transactivator could not be ascribed to differences in genetic background because mice in a mixed genetic background and in congenic mouse lines showed similar results.</p> <p>Conclusions</p> <p>The purpose of this study is to report our negative experience with previously functional transactivator mice, to raise caution in the use of tet-based transgenic mouse lines and to reinforce the need for controls to ensure the stable functionality of generated tetracycline-controlled transactivators over time.</p